Our Quality Spare

Inspection Tackles

All incoming parts thoroughly inspected by Special advanced measuring gauges. Assuring 100% accuracy of the spares while the functioning of the pump

3 Seg Carbon Thrust Pad Assembly

All motors are fitted with tilting pad carbon / S.S . Thrust bearings with excellent surface finish.

4 Seg Carbon Thrust Pad Assembly

All motors are fitted with tilting pad carbon / S.S . Thrust bearings with excellent surface finish. More life under extra high depth Bore wells.

6 Seg Carbon Thrust Pad Assembly

All motors are fitted with tilting pad carbon / S.S . Thrust bearings with excellent surface finish. More life under extra high depth Bore wells.

All Casting Parts

All casting parts are FG220 grade with 180-220 BHN hardness is used. All castings are painted with epoxy paint. Higher strength. No rusting under water.

Bearing Bush LTB4

Gunmetal Bush is made from LTB4 material which gives long life to the motors.More number of bushes are used for higher stages which gives excellent mechanical stability.

Carbon Bush

Carbon Bush is provided to give lower wear resistance to the bearing diameter of motor shafts. This gives long life to the motors.

Inprocess Rotors V3,V4,V6

Rotor is made from CRNO grade stamping with E.C. Grade Copper bar & end rings. Rotor ends are brazed with 2 % silver brazing rod.

N Type Radial Flow Stage Assembly

Stage bowls of Radial flow pumps are made of FG220 graded castings.Polycarbonate diffusers with S.S. ring are securely fitted in casing.

Poly Carbonate Parts

All polycarbonate parts used are of 20% Glass filled material which gives long life in running operation.

Pump Shaft

All pump shafts are of SS 410 material .

Rubber Parts

All rubber parts are using nitrile rubber having 75/80 shor hardness. .

Spline Coupling Rotor

SS 431 material is used which have hardness from28 to 32 HRC.

SS Impellers

All SS Impellers are made of SS 410 material and thoroughly balanced dynamically.

SS Sleeve and coupling

Tanon & slot type S.S. coupling typically lada design gives extended life.No maintenance and No replacement. All SS Sleeves are made of SS410 material as to with stand life long operation.

Stator Stack

Stamping with CRNO Grade and are finished with progressive die.

Stator V4

Stator is made of CRNO Grade stamping with less watt loss. Stator Jacket is made of SS material which covers entire stack length..

V4 Diffusar Assembly

Virgin NORYL material is used for impeller & diffusers. S.S. neck ring at all wear areas. Gives extended life, better dimensional accuracy even under water.

V4 Slim Finish Rotor

Rotor is made from CRNO grade stamping with E.C. Grade Copper bar & end rings. Rotor ends are brazed with 2 % silver brazing rod.

V6 Finish Rotor

Rotor is made from CRNO grade stamping with E.C. Grade Copper bar & end rings. Rotor ends are brazed with 2 % silver brazing rod.

Winding Wire

High quality E.C. grade copper is used. Triple coated polyester wrapped winding wire. Better efficiency & More Life Under low voltage.

Motor Shaft

Hardened And Toughened SS 431 and SS 410 Grade Material.